Hammer Mill: Grinder

 

Hammer Mill: Grinder

 

Appropriate a selection of the operating guidelines for a hammer mill can maximize expertise and enhance the uniforms of the product obtained:

 

Material to be ground:

Raw materials act differently when they are grounded; the factors that have the greatest influence on milling properties are toughness and flexibility. A rise of moisture in the product disturbs these two specifications and step up them. Analytically, 1% of the increase in humidity means 7% of more power to achieve the same result.

 

With indistinguishable product moisture measure and continual machine settings, the following circumstantial bond can be accepted for grain:

Mixture ratio: 

Oats: Barley: Wheat: Corn 

1     : 2         : 3         : 4

 

Peripheral speed:

Each product has its own gilt-edge milling speed. With increasing tangential speed, the granulation becomes first-rate. However, power demands will rise, while the thorough-paced will decrease.

 

The below sum up these rates in m/sec:

 

Millet (baajara)                     48 m/sec

 

Maize (makka)                    52 m/sec

 

Wheat (gehoon)                 65 m/sec

 

Rye bran (raeechokar)     75 m/sec

 

Barley (jau)                        105 m/sec

 

Bran (chokar)                    110 m/sec

 

Sieves configuration:

The sieve hammer mills are frequently driven steel sheets of 2 - 3 mm.
Density, with holes whose diameter is customarily the same to or less than the diameter of the mass. Bulkier holes mean higher open area and accordingly increased a performance altogether, decreased particular power requirements, rough product, a shorter useful lifespan of the sieves. If pierce chrome is used, thicker sheet metal could be used for balance reasons. Even with else ways identical conditions in terms of the diameter of the perforations and the open sieve area, this opportunity can make the motion of the lesser medium through the sieve more difficult, hence: the interrupt the achievement would fall; the product would become excellent; the specific ability requirement would get bigger.

In sieves, the supervision of perforation is generally aligned with the more significant preference of linen. Backpedal perforation must be specifically requested

Boost your workflow with Ecostan HammerMill, check its Advanced Technology features as:

Hammer Mill Machinery with Cyclone:

Model No	Production	Required Power
HM 120	upto 7000 KG/HR	199.5 HP
HM 100	upto 5000 KG/HR	151 HP
HM 60	upto  3000 KG/HR	84 HP
HM 50	upto  2000 KG/HR	65 HP
HM 40	upto  1300 KG/HR	52.5 HP
HM 20	upto  600 KG/HR	28 HP
HM 10	upto  250 KG/HR	15 HP