6 Common Problems In The Operation Of Briquette Machine

Briquette machine is used for making briquettes from waste materials and human beings can make use of these briquettes as fuel. However, there are a lot of benefits of briquetting machine such as it reduces the chances of pollution because instead of burning waste material, human beings can reuse them. But, during the operating of briquette machine some common problems occur that are described following:

 

It always makes noise:

The reason behind it is the water content and the temperature in the waste material are out of the normal range. And the only solution is drying waste material by the dryer to make sure that the materials are kept at proper humidity and temperature. The damaged components of the briquette machine are the reason of makes noise. So, you ought to replace them immediately.

 

It restarts frequently:

Replicate restart of the briquette machine is normally caused by the low power supply that can’t drive the machine to work usually. It would better suit the remedy to the case to solve this issue. Initially, the AVO meter detects the power supply voltage of the briquette machine. It is better detected under the situation that the machine is loaded so that to judge whether there is any power supply difficulty.

 

The oil pressure of briquette machine is inadequate:

There is inadequate oil pressure while the running procedure of the briquette machine. The reason is causing such a concern might be the deformation of the joint gasket and the blockage of oil suction. It ought to be washed and cleaned immediately to make sure the cleanness of briquette machine equipment if the oil suction is blocked. It ought to be replaced the deformed gasket with a new one if the joint gasket is deformed so that the machine can work efficiently and normally.

 

Water resistance of briquette machine:

The suspension installation way is adopted by a lot of users while the installation of the briquette machine. But there is still a gap between the bracket hinge and the briquette machine. It is snowing or raining, the water can leak into the machine that is the reason for the damage. Thus, the waterproofing measure ought to be adopted while installation. 

 

The deformation of completed products:

Occasionally, after shaped, the completed products are deformed by the entire procedure and the reason behind it is that the waste materials hold a large amount of water. It can reduce the water content in the waste materials to solve this issue. Through the dryer, the waste material can be dried. 

 

The briquette machine produces a large amount of dust:

The cyclone dust collector can be equipped as the corollary equipment if the machine generates a large amount of dust while the briquetting procedure. In the briquette machine, the dust collector has the benefit of enhancing the working efficiency greatly and cleaning the dust immediately. 

 

Final words:

The above-discussed points are described the common issues in the operation of the briquette machine. The improper operation may decrease the working efficiency of the briquette machine while generating the briquettes. If you like this informative blog, please share it with your contacts.